1970 360 exhaust routing pic?

[redstone65]

Does anyone have a picture of correct, stock exhaust routing for a 360? Looking at the schematic, it looks like the drivers side exhaust loops under the oil pan or something. Can't tell what I'm looking at.

The one I just pulled out was pure, booger-welded craziness.

[Busboy]

Yes it goes under the trans bellhousing.

[redstone65]

Thanks Busboy. The one I just cut out was routed behind the trans, under the tail housing. They didn't leave enough room to actually mate it to the manifolds though. So, out it came.

Pic:

[Busboy]

Yeah that's definitely a cobble job. I buy new header pipes from Napa or Summit.

[redstone65]

Thanks for the advice. I think I found the parts:

Passenger side (main): https://www.napaonline.com/en/p/EXT40516

Driver side (crossover): https://www.napaonline.com/en/p/EXT42371

The new engine is from a 74 and has the ribbed exhaust manifolds. NAPA's site says the crossover pipe won't fit a 74. But, they look like the ports line up the same as the block style manifolds from the old engine (70 model). Is that right?

[Busboy]

Those are definitely the part numbers that i have used on two projects, a 67 and a 72. I think the chassis is the issue not the engine as far as year model.