passing gear

caya1382 · Post by **caya1382** » Wed Jan 18, 2017 8:44 am

I have a quick question. I built a 302 and it has a weber carb and I can't seem to find a passing or kickdown bracket for it . Do they make one or do I have to make my own ? Any ideas for a fix?

Post by **Ranchero50** » Wed Jan 18, 2017 3:01 pm

Weber... Methinks you'll need to fab one up. You'll need to get the lever length off a 2100 so the geometry is correct.

caya1382 · Post by **caya1382** » Wed Jan 18, 2017 5:33 pm

I actually have a kickdown bar from a 2100. You think cutting the end off and welding a homemade piece that adapts to the weber us as good as I am going to find.

windhamdw · Post by **windhamdw** » Tue Feb 14, 2017 2:38 pm

Edelbrock makes a few kickdown brackets, maybe one of those will work, but you will still need to get a cable system to work with it, i think Locker make one.

Post by **Ranchero50** » Tue Feb 14, 2017 2:58 pm

windhamdw wrote:Edelbrock makes a few kickdown brackets, maybe one of those will work, but you will still need to get a cable system to work with it, i think Locker make one.

Post up an Edel carb that does Ford kickdown, I couldn't find one a couple months ago. Lots of Cheby stuff but no Ford.

windhamdw · Post by **windhamdw** » Tue Feb 14, 2017 4:00 pm

not sure which one will work thats why i put maybe one will work, but i don't think you will need a bracket if you use the lokar kickdown cable (Lokar KD-20C6HT Ford C6).

colnago · Post by **colnago** » Tue Feb 14, 2017 5:02 pm

The Edelbrock bracket number for Ford is 1483.

Joseph

windhamdw · Post by **windhamdw** » Thu Feb 16, 2017 8:52 am

I just ordered this one for mine, http://www.ebay.com/itm/Ford-C6-Stainle ... 2058129935

for $30 it looks just like the Lokar but a lot cheaper.

The FORDification.com Forums

passing gear

passing gear

Re: passing gear

Re: passing gear

Re: passing gear

Re: passing gear

Re: passing gear

Re: passing gear

Re: passing gear