1974 ford f100 240 3 speed on column

[gregamorton]

Guys yall have any idea on my setup if it uses a 10" or 11" clutch? I bought one for my 300 3 speed OD from a place on ebay and they are super cheap and a direct manufacture. I know it needs to be 10 spline 1 1/16 but the 10" or 11" is whats throwing me off. I dont want to tear down till i have every thing to replace. Thanks for the help in advance!

[averagef250]

There is some funky crap with Ford truck pressure plates before the 1980's. Some flywheels have 42 different bolt patterns in them, some have one. I make a lot of flywheels. The Ford ones I make only use the modern (80's+) pressure plate patterns because the old stuff is so goofy.

Usually you can easily measure the clutch size through the dust cover opening.

[gregamorton]

here is the fellow that I bought my last kit from for the 300 OD 3speed. http://www.ebay.com/itm/Ford-Mercury-10 ... 2e987a0a9c I will call when I figure out the size. I would not mind buying a flywheel at the same time. Now that you said that I believe my 300 flywheel had 3 sets of holes for different pressure plates.