WANTED new 1967 body side molding

[mrgreed]

I just got a new project truck. It is a 1967 F250, custom cab, camper special. I have been looking for new body side molding. the three books that I have don't have any body side molding for 67. does anyone know where I can find new body side molding?

[flyboy2610]

LMC truck and Dennis Carpenter both have a good selection of molding.
Do you have their catalogs? You can contact them via the links and resources tab at the top of this page.

[mrgreed]

I will give them a call and see what they carry. The LMC book that I have goes from 68-69 & 70-72 for this body side molding.

Thanks,
mrgreed...

[mrgreed]

I gave LMC a call -Unfortunately, they do not carry 1967 body side molding. They carry 68 thru 72 .

Does anyone have any suggestions?

Does anyone know how much differents there is from 67 to 68?


Mrgreed..

[FORDification]

DennisCarpenter.com has the '67 moldings. They reproduce them using the original factory tooling....but be prepared to pay. The complete set is $450.

The '67 moldings are the same style as the '68-'72 except that it's 1/4" narrower. You could easily remove the retaining clips and replace them with the clips for the wider trim and install that instead. Check out the TRIM & INSIGNIAS page for more information, with pictures showing the differences.

[mrgreed]

Thanks -I must have over looked that trim page. That was helpfull.

Dennis-Carpenter.com is a real cool sight. They got every thing that I need. Yes it is a little expensive but, at least they are available. I was starting to think that I could not get them at all.

thanks again,
mrgreed...