clutch linkage does not line up

69Dwayne · Post by **69Dwayne** » Wed Sep 28, 2005 8:42 pm

To start with my clutch works fine. However when I look at the rod going from the frame to the bell housing it does not line up well. It goes up from the frame to the engine not straight across. Is there an adjustment for this?

Freightrain · Post by **Freightrain** » Thu Sep 29, 2005 8:24 am

I've never actually seen one that is straight. All of my vehicles are running at different angles. Especially the push rod going to throw out arm. These are always at off angles. Never had any issues with them so I leave it alone.

heep70 · Post by **heep70** » Thu Sep 29, 2005 9:58 am

I agree with Freightrain, they are not striaght.

69Dwayne · Post by **69Dwayne** » Thu Sep 29, 2005 8:11 pm

OK, I am not going to worry about it. As I said the clutch works fine. Thanks very much for the info.