What did you do to YOUR bump today?

[flyboy2610]

Yesterday, I loaded finished loading the truck and loaded the trailer with bagged leaves. Hauled them to the dump this morning. I wish the landfill were open later in the afternoon, cause then I could drive the bump/trailer to work and dump the leaves after I got off.
Still have 5 bags of leaves to start the next load, and still have a lot of leaves left on the trees! (I hate that oak tree. )

[1971ford]

I got a a hood and a dash pad in great condition for the '69 for $80, well that was yesterday.
Today i will be installing the dash pad and start painting the hood

[TexasTruck72]

Finally got nice chrome gas cap for it. Makes the driver side look a whole lot nicer.
No more old crusty, rotten rubber seal, leaky gas cap!
Small things can really make you feel better.

[1971ford]

Kicked it

Bumpside abusement!!!

[mrsnicks]

Replaced the leaky front passenger wheel cylinder. Got dark so have to wait until tomorrow to get it all back together.... Busted 2 knuckles and sliced the web between my thumb and index finger. Let me say Darn I can't wait until I upgrade to front disc brakes.. I hate drum brake hardware.

Patrick

[Jarred Hodges]

took it apart so I can install a new cam and lifters

[Pipes71]

put the rear leaf springs on, sandblasted all the mounts and trans crossmember, rear sport bumper brackets, painted them all, dug out some inner fenders to get ready for paint, ordered a drivers side cab mount because I found a rust spot on the one on my cab I over looked. ordered the bed bolts. scuffed up the primer on cab for paint, under coated the cab, except for cab mount area. made arrangements to get the cab off the stand and back on the new frame just a few things so far

[1971ford]

put the rear leaf springs on, sandblasted all the mounts and trans crossmember, rear sport bumper brackets, painted them all, dug out some inner fenders to get ready for paint, ordered a drivers side cab mount because I found a rust spot on the one on my cab I over looked. ordered the bed bolts. scuffed up the primer on cab for paint, under coated the cab, except for cab mount area. made arrangements to get the cab off the stand and back on the new frame just a few things so far

YAY!
I want to see pics!!!

[austin]

yesterday i welded a receiver hitch to my bumper and today i paint the whole bumper flat black it looks so so much beter

i also noticed i have a 70-72 lower valance panel i may weld up the holes so it looks normal on my 69

[bigredball90]

new kyb gas a adjust shocks all the way around

[papabug71]

Hey FISHERTECH, welcome to FORDification ! That truck is going to be HUGE! More long than huge but still, its going to be massive.

Today I pulled the radiator, had it rodded & put on a fresh coat of paint. It looks good.

We need pics or it didn't happen

I forgot this was a picture thread !!

[bigredball90]

pulled the motor

[1968Ranger]

Filled her up and drove to town. First time since new carb and intake put on. Filled up again and figured MPG. WOW 15.16 mpg. Im shocked

[DGrant09]

Kicked it

Bumpside abusement!!!

Careful now, you'll end up with a dent side!

[67_p_car]

picked up thing 1 and 2 from school and took them to the dentist before the insurance runs out...