Input shaft data for 302 applications

Chasbod · Post by **Chasbod** » Wed Feb 18, 2009 2:16 pm

What is the input shaft dia, length, spline count for 302 5 spd applications?

For the output, is it 28 or 31 splines? Simple matter of finding the right yoke and mating up to the driveshaft?

Thanks

fordman · Post by **fordman** » Wed Feb 18, 2009 5:42 pm

the u joints come in different sizes for many applications. what 5 speed are you looking for a rear yoke for?

MadMaxetc · Post by **MadMaxetc** » Wed Feb 18, 2009 8:06 pm

not sure...

but the one off my 3 speed toploader (ford 3.03) fit right into my T-5

Chasbod · Post by **Chasbod** » Thu Feb 19, 2009 11:44 am

I think I have learned that the input shafts need to be 1 1/16, 10 spline...still researching the length.

The output will be either 28 or 31 spline. T-5's had 28.

The FORDification.com Forums

Input shaft data for 302 applications

Input shaft data for 302 applications

Re: Input shaft data for 302 applications

Re: Input shaft data for 302 applications

Re: Input shaft data for 302 applications