95 Mustang Oil Pressure Sensor

Engine, ignition, fuel, cooling, exhaust

Moderators: Ranchero50, DuckRyder

Post Reply
User avatar
towens
New Member
New Member
Posts: 63
Joined: Sat Jan 21, 2006 6:05 pm
Location: Utah, Kaysville

95 Mustang Oil Pressure Sensor

Post by towens »

Hey Everyone,

I need to replace my oil pressure sensor on my '95 Mustang. The sensor isn't quite in the right spot :roll: so I will need to loosen my serpentine belt remove my alternator and then I will be able to access my sensor. I have looked in the Haynes repair manual and it states that the tension pulley is located on the passenger side of the car adjacent to the lower crankshaft pulley. I have looked over and over again and I can't seem to find it. Can anyone help a visually challenged ADHD DIY mechanic? It is the V6 C4 model is that helps at all.

THANKS FOR YOUR TIME

TOWENS
TRAVIS OWENS
"Never argue with an idiot; they will only drag you down to their level" -Anonymous

1972 F-250 CAMPER SPEC: SPORT CUSTOM 360 2WD; C6

1995 Ford Mustang V6; C4

1981 Honda 70c Passport Cub

1982 Honda Trail 110
Top
Jake11
Blue Oval Fanatic
Blue Oval Fanatic
Posts: 826
Joined: Mon Nov 21, 2005 1:31 am

Re: 95 Mustang Oil Pressure Sensor

Post by Jake11 »

It's the one on a lever with a square hole on it. The square hole is for a breaker bar to back the tension off. It's
got a big clock spring inside the housing. If you don't have a diagram of how the belt winds around all the pullys,
take a picture or make a diagram so you can get the belt back on the same way. Jake
Top
Post Reply

Return to “Engine”