Hi All
I've got a vibration in my truck and I don't think it's the good kind. '71 F250 with a 360 and C6. New engine with 10k mi, tranny needs a rebuild due to slight slip second gear to third, no leaks in the rear end and the drive shaft doesn't seem to have any play in it.
On the freeway from about 60mph up I feel a vibration in the steering wheel about once per second. Gets a little more pronounced as I speed up. Seems to diminish when I take my foot off the gas. Any ideas as to what might be causing this?
Thanks in advance.
Vibration
Moderators: FORDification, 70_F100
- flistr8
- New Member
- Posts: 47
- Joined: Sun Jul 15, 2007 11:28 am
- Location: Stockton, California
- basketcase0302
- 100% FORDified!
- Posts: 6805
- Joined: Thu Jan 26, 2006 7:11 am
- Location: Hawthorne, Florida
re: Vibration
flister8,
Jack the front end off the ground and check:
1) Your tie rods.
2) Wheel bearings.
3) Steering box.
4) I'd also have the front alignment checked and front tires checked for balance.
Basketcase
A vibration in the steering wheel will usually indicate that there is a problem there, in the steering.a vibration in the steering wheel
Jack the front end off the ground and check:
1) Your tie rods.
2) Wheel bearings.
3) Steering box.
4) I'd also have the front alignment checked and front tires checked for balance.
Basketcase
Jeff
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
- Wes
- Blue Oval Fan
- Posts: 732
- Joined: Fri Oct 21, 2005 6:04 pm
- Location: California, Southern& Lake Havasu Az
Have or check the out the front tires for a separation of the outer tread and casing.
Wes
http://www.fordification.com/galleries/ ... ?cat=10402
67 F250 High boy
69 Bronco
If you can't see fit to stand behind Our Troops...Please stand in front of them
http://www.fordification.com/galleries/ ... ?cat=10402
67 F250 High boy
69 Bronco
If you can't see fit to stand behind Our Troops...Please stand in front of them
-
- New Member
- Posts: 162
- Joined: Tue Sep 26, 2006 4:34 pm
- Location: Montana
re: Vibration
tossed one of the lead balancing weights from your wheel maybe
Jim
'75 Ford Highboy 390 4spd
'75 Ford Highboy 390 4spd
-
- 100% FORDified!
- Posts: 22329
- Joined: Sun Aug 28, 2005 8:17 pm
- Location: Kansas, Ottawa
- Contact:
- Joshpow
- 100% FORDified!
- Posts: 1790
- Joined: Fri Jan 21, 2005 10:43 am
- Location: Virginia
- Contact:
re: Vibration
I agree. Front end problems sound most logical. I would suspect tire balance out or maybe a wheel bearing. Another possibility is that the dust edge has rusted off the brake drum. My 72 has that problem, so the brake drumis out of balance causing a jiggle in the front. Just my .
Josh
72 F-100 Ranger XLT SWB
71 F-100 Custom SWB
67 F-350 Dually Dump
02 F-250 Stroke
http://www.cardomain.com/ride/2972100
72 F-100 Ranger XLT SWB
71 F-100 Custom SWB
67 F-350 Dually Dump
02 F-250 Stroke
http://www.cardomain.com/ride/2972100
-
- New Member
- Posts: 155
- Joined: Sun Sep 10, 2006 2:17 pm
- Location: Washington, Vancouver
re: Vibration
A rhythmic vibration would be an alignment thing, or at least, that's my guess.
Or, you could have a mariachi band under the hood.
Or, you could have a mariachi band under the hood.
RON
Excuse me while I whip this out
Excuse me while I whip this out
- flistr8
- New Member
- Posts: 47
- Joined: Sun Jul 15, 2007 11:28 am
- Location: Stockton, California
re: Vibration
Thanks for the reply's everybody. It never occured to me it might be coming from the front end. Truck tracks straight as an arrow, only problem is it doesn't want to return to center. Think that might be a castor problem. Got a new steering box on it. Will start with getting the wheels balanced and check the tread for seperation.
- Wes
- Blue Oval Fan
- Posts: 732
- Joined: Fri Oct 21, 2005 6:04 pm
- Location: California, Southern& Lake Havasu Az
make sure your king pins are greased and turn freely, is the 1st thing I check on king pin truck, bushed or bearing,
when I get a compliant of not returning to center. Then the alignment.
when I get a compliant of not returning to center. Then the alignment.
Wes
http://www.fordification.com/galleries/ ... ?cat=10402
67 F250 High boy
69 Bronco
If you can't see fit to stand behind Our Troops...Please stand in front of them
http://www.fordification.com/galleries/ ... ?cat=10402
67 F250 High boy
69 Bronco
If you can't see fit to stand behind Our Troops...Please stand in front of them