dana 24 transfer case

53 4x4 · Post by **53 4x4** » Sat May 21, 2005 3:08 pm

hello all I'm new to this site and hope I'm asking this question in the right place ,and to the right people .I need a schematic diagram for a dana model 24 transfer case which is currently in a 1969 f-250 highboy.Any and all info on this is appreciated.The trans is a np435 the front axle is a h.d. dana 44 solid and the rear I think is a dana 60 (I'm not sure how to i.d. the rear)

thanks in advance
Jason

heep70 · Post by **heep70** » Sat May 21, 2005 9:06 pm

and

to the site. Yes this is the place to be.

I got some info in a manual on the D24 T-case. Its not alot. I will start scanning it. PM me your email addy and I will send it to you.

Also, the rearend is a D60, 16 spline full floater. It may have Power-loc, Trac-loc or open diff.

Mark (4x4x4crewcab) might have some info on it also.

Post by **FORDification** » Sat May 21, 2005 9:38 pm

Welcome Jason!

I just scanned and posted two exploded-view diagrams, one of which should be what you asked for. These were scanned from the Ford Master Parts catalog, but they didn't specify transfer case model numbers....so I just scanned 'em both:

Transfer case - Four Wheel Drive - Dana (Spicer)
1966-1972 F100

Transfer case - Four Wheel Drive - Dana (Spicer)
1964-1965 F100, 1964-1972 F250

For further reference, these were posted to PAGE 3 of the Schematics and Diagrams section.

trukcrazy · Post by **trukcrazy** » Sat May 21, 2005 11:10 pm

and

Jason. Go to the welcome mat and introduce yourself to the rest of the folks here. Glad to have you aboard

. John.

Faithful Old Road Dog · Mon May 23, 2005 12:46 am

Welcome! Let me guess... your t-case pops out of gear.

53 4x4 · Post by **53 4x4** » Thu May 26, 2005 9:06 pm

thanks to everyone that replied and especially those that sent the info . All that I recieved was very useful .I will post updates as the 53 project progressess.

thanks again
Jason

Drednme · Post by **Drednme** » Fri May 27, 2005 12:06 am

If yours is popping out of gear I fixed mine with a two foot long board propped up between the shifter and the firewall, works really good until I can find the time to tear into it.

heep70 · Post by **heep70** » Fri May 27, 2005 11:21 am

Drednme wrote:If yours is popping out of gear I fixed mine with a two foot long board propped up between the shifter and the firewall, works really good until I can find the time to tear into it.

On that two foot long baord. Does it have to be a certain type of wood

Drednme · Post by **Drednme** » Fri May 27, 2005 11:08 pm

Pine is the only way to go!

The FORDification.com Forums

dana 24 transfer case

dana 24 transfer case

re: dana 24 transfer case

re: dana 24 transfer case

re: dana 24 transfer case

re: dana 24 transfer case

re: dana 24 transfer case

re: dana 24 transfer case

Re: re: dana 24 transfer case

re: dana 24 transfer case