3 speed shifters.

ZOEGA · Post by **ZOEGA** » Thu Oct 04, 2007 9:11 pm

Hi people!

I'll explain with some pictures...
I have a 3spd manual gerabox:

But this two axels, shifters (I don't know what's called), circuled in red, are from another truck (chevy C-10), and they wont work with my setup:

I know that this direction column with those rods above was runnig on a F100...
I've been looking for pics, and measures, but it's hard to find anything specific of the F100...

There are many models of those shiftes, and I dont know witch one is the right one for me...

Anybody have a clue by chance?

Thanks!

AustinTom · Post by **AustinTom** » Fri Oct 05, 2007 9:54 am

None of those transmissions look like the 3 speed that was in my truck. maybe I had the wrong transmission, but I know it was a top loader.

Finleyphoto · Post by **Finleyphoto** » Fri Oct 05, 2007 10:58 am

This is that South American truck.

They were... uh... different.

Lot of hold over stuff from the early 60's put onto bumpside's

Dennis

Post by **FORDification** » Fri Oct 05, 2007 4:41 pm

Here's what the factory shift arms look like on a '72 American truck's 3-speed:

AustinTom · Post by **AustinTom** » Fri Oct 05, 2007 5:23 pm

that is also not what mine looked like

ZOEGA · Post by **ZOEGA** » Fri Oct 05, 2007 8:36 pm

I recived other model, this one seems like a real setup of F100's rods (south american, at least)...

fmartin_gila1 · Post by **fmartin_gila1** » Sat Oct 06, 2007 4:05 am

If that first pic is the tranny to be used, it looks like the earlier narrow pattern with a 1 3/8 diameter input shaft that was replaced in 1964 with the wide pattern on the pic that Keith put up. Looks like all the other pics are also the earlier pattern too. If you do need to use that narrow pattern mount, with the large input shaft, please be aware that there were two different lengths of the input shaft depending on if it was used in a car or pickup.
Fred

fmartin_gila1 · Post by **fmartin_gila1** » Sat Oct 06, 2007 4:16 am

The last pic you put up was not showing on my computer when I posted a few minutes ago, but that looks like the matching levers you need for the column you are displaying. Make sure you have the proper stickout on the input shaft and you should be good to go.
Fred

mrung0wa · Post by **mrung0wa** » Sat Oct 06, 2007 9:01 am

That tranny looks like the one that I had in my 65 mustang with a 200.
I believe there called "303's"

Lawrence

ZOEGA · Post by **ZOEGA** » Mon Oct 15, 2007 8:24 pm

I found the right ones!

The FORDification.com Forums

3 speed shifters.

3 speed shifters.

re: 3 speed shifters.

re: 3 speed shifters.

: 3 speed shifters.

re: 3 speed shifters.

re: 3 speed shifters.

re: 3 speed shifters.

: 3 speed shifters.